021-39529839
电 话：021-39526589-8004
联系人：王倩
手 机：15308020014
地 址： 中国 上海 嘉定区嘉涌路99弄6号713
更新时间：2026-06-01 浏览数：62
所属行业：机械设备> 渔业机械> 雾度计
发货地址：
产品规格：--
产品数量：1
包装说明：--
单 价：面议
| 品牌 | 材质 | ||
| 性能 | 流量 | ||
| 扬程 | 转速 | ||
| 电压 | 叶轮吸入方式 | ||
| 驱动方式 | 输送介质 | ||
| 泵轴位置 | 叶轮数目 | ||
| 叶轮结构 | 汽蚀余量 | ||
| 吸入口径 | 排出口径 | ||
| 防护等级 | 执行标准 | ||
| 产品认证 | 外形尺寸 | - | |
| 重量 | - |
日本油研轴向柱塞泵规格，阐述YUKEN柱塞泵
上海乾拓贸易有限公司
企业QQ：2880626087
电话；
手机；（微信）
邮箱；@163.com
联系人；杨婷玉
地址：上海市嘉定区江桥嘉涌路99弄6号713室
必须小心维持控制
between -16.7 and 50 kPa (5 in.Hg Vacuum and 7 PSIG).
For piping to the suction port, use the pipes of the same
diametre as that of the specified pipe flange to be used. Make
Refer to the suitable single pump as shown below.
Inboard Pump
Same as "A37"
Outboard Pump
Same as "A16"能导致的工using steel pipes for the suction or discharge ports,
excessive load from the piping to the pump generates excessive
noise.
Whenever there is fear of excessive load, please use rubber
hoses.
7. Suction Piping of piping should be less than 1 m (3.3 ft.), and the
pipe end should be submerged in oil.
9.Bleeding Air
It may be necessary to bleed air from pump case and outlet
line to remove causes of vibration. An air bleed valve
(Model No. ST1004-?-10?, Catalogue No.: Pub. EC-
3001) is recommended for this purpose.
[Recommended Drain Piping Size]
(Single Pump & Variable/Fixed Double Pump)
Instructions
No.2
"A" Series Piston Pumps
Single, Double, Variable / Fixed Double for each side of the pump作油污染
故障并缩短from bending or thrust.
Maximum permissible misalignment is less than 0.1 mm (.
004 inches) TIR and maximum permissible misangular is
less than 0.2?.
5. Suction Pressure
Permissible suction pressure at inlet port of the pump is
Fix drain pipee the pump is installed above the oil level, the suction
piping and suction line filter should be located lower than the
pump position to prevent air in the suction line.
Install drain piping according to the chart and ensure that
pressure within the pump housing should be maintained at
a normal pressure of less than 0.1 MPa (14.5 PSI) and surge
pressure of less than 0.5 MPa (72.5 PSI).
Length
sure that the height of the pump suction port is within one
metre (3.3 ft) from the oil level in the reservoir.
6. Hints了设备的使用寿命。 请保持
NAS级别10级内的污染程度。
吸入口必须至少配备100微米
（150目）储罐式过滤器和返回管路必须有
10μm以下的线型过滤器。
3.安装
日本油研轴向柱塞泵规格，阐述YUKEN柱塞泵
您是第34461593位访客
公司主营：德国SICK传感器，FESTO比例阀，德国FESTO电磁阀，ASCO电磁阀，NORGREN电磁阀，LEUZE传感器，CKD电磁阀，CKD气缸 沪ICP备09006758号-10
乾拓贸易是销售气缸,继电器的公司,以SMC气缸,PILZ继电器,FESTO气缸为主,产品型号规格齐全,报价合理,可满足不同客户的需求!
版权所有：上海乾拓贸易有限公司
