电 话:021-39526589-8004
联系人:覃小敏
手 机:19117262520
地 址: 中国 上海 嘉定区嘉涌路99弄6号713

更新时间:2022-11-18 浏览数:66
所属行业:化工> 泵(化工)> 其他泵
发货地址:
产品规格:--
产品数量:1
包装说明:--
单 价:面议
油研先导式溢流阀,概述YUKEN溢流阀
上海乾拓贸易有限公司
企业QQ:2880626087
电话;
手机;(微信)
邮箱;@163.com
联系人;杨婷玉
地址:上海市嘉定区江桥嘉涌路99弄6号713室
电磁式换向阀。 管道之间
电磁阀直接安装在两个上
安osity ranging between 15 - 400 mm2 /s (77 - 1800 SSU).
Oil temperatures between -15/+70°C (5 - 158°F).
Use hydraulic fluids which satisfy the recommended visco
sity and oil temperatures given above.C(5 - 158°F)之间。
使用满足上述粘度和油温的液压油。以通过电信号远程卸载
螺线管,或连全阀并与安全阀通气口hate ester fluid is used,
prefix "F-" to the m odel number because the s
pecial seals (fluororubber) are required to be used.
Use water-gly col fluid.
Instructions
To adjust the pressure, loosen the lock nut and t
urn the handle slowly clockwise for higher pressur
es or anti-clockwise
for lower pressures. After adjustments, do not forge
t to tighten the lock nut.
Fluid Types连接。泵
压力可以使用下表中列出的任何类型的液压油。
的粘度和油温
Use phososity ranging between 15 - 400 mm2 /s (77 - 1800 SSU).
Oil temperatures between -15/+70°C (5 - 158°F).
Use hydraulic fluids which satisfy the recommended visco
sity and oil temperatures given above.C(5 - 158°F)之间。
使用满足上述粘度和油温的液压油。以通过电信号远程卸载
螺线管,或连全阀并与安全阀通气口hate ester fluid is used,
prefix "F-" to the m odel number because the s
pecial seals (fluororubber) are required to be used.
Use water-gly col fluid.
Instructions
To adjust the pressure, loosen the lock nut and t
urn the handle slowly clockwise for higher pressur
es or anti-clockwise
for lower pressures. After adjustments, do not forge
t to tighten the lock nut.
Fluid Types连接。泵
压力可以使用下表中列出的任何类型的液压油。
的粘度和油温phate ester or poly ol ester fluid. Whe
n phosp
Piping of the tank line should not be connected to any
tank line of the other valves, but connected directly t
o the tank.
Hydraulic Fluids
Any type of hydraulic fluids listed in the table below c
n be used.
Recommended Viscosity and Oil Temperatures
Visc
粘度介于15 - 400 mm2 / s(77 - 1800 SSU)之
油研先导式溢流阀,概述YUKEN溢流阀