电 话:028-86751041-8004
联系人:王倩
手 机:15308020014
地 址: 中国 上海 嘉定区嘉涌路99弄6号713

更新时间:2022-11-18 浏览数:41
所属行业:通信> 传输交换设备> 光纤放大器
发货地址:
产品规格:--
产品数量:1
包装说明:--
单 价:面议
日本欧姆龙原装光纤放大器性能介绍
上海乾拓贸易有限公司
企业QQ:2880626087
电话;
手机;(微信)
邮箱;@163.com
地址:上海市嘉定区江桥嘉涌路99弄6号楼713室
Case Polybutylene terephthalate (PBT) Cover Polycarbonate Accessories Instruction manual
Item Model E3X-CN11 Rated current 2.5 A Rated voltage 50 V
Contact resistance
20 mΩ max. (20 mVDC max., 100 mA max.) (The above figure is for connection to the Amplifier Unit
and the adjacent Connector. It does not include the conductor resistance of the cable.) Number of insertions Destruction:
50 times (for connection to the Amplifier Unit and the adjacent Connector)
Housing Polybutylene terephthalate (PBT) Contact Phosphor bronze/gold-plated nickel Weight (packed state) Approx. 55 g
2100 E32-T11 + E39-F1
2000 E32-T14
output short-circuit protection, output reverse polarity protection Timer function ON/OFF-delay timer:
Pre-wired model: Approx. 100 g, Model with connector: Approx. 55 g
teaching Protection circuits Power supply reverse polarity protection,
Receiver side Incandescent lamp: 10,000 lux max. Sunlight: 20,000 lux max.
Ambient temperature range
Operating: Groups of 1 to 3 Amplifiers: ?25°C to 55°C Groups of 4 to 11 Amplifiers:
?25°C to 50°C Groups of 12 to 16 Amplifiers: ?25°C to 45°C Storage: ?30°C to 70°C
(with no icing or condensation) Ambient humidity range Operating and storage: 35% to 85%
(with no condensation) Insulation resistance 20 MΩ. min. (at 500 VDC)
10 ms (each fixed) Mutual interference prevention Up to 5 Amplifiers (optically synchronized)
Ambient illumination
Immediately determine operation and amount of light with a simple, bright display.
General-purpose capabilities to simply handle a broad range of applications.
Digital display and direct key setting Standard models Item Model E3X-SD@ Light source
Y and Z directions Shock resistance Destruction: 500 m/s2, for 3 times each in X,
Y and Z directions Degree of protection IEC 60529 IP50 (with Protective Cover attached)
Connection method Pre-wired (standard cable length: 2 m), or connector Weight (packed state)
Dielectric strength 1,000 VAC at 50/60 Hz for 1 minute (*) Vibration resistance Destruction:
10 to 55 Hz with a 1.5-mm double amplitude for 2 hrs each in X,
500 E32-T11R + E39-F2
220 E32-T11 + E39-F2
The Standard for Fiber Amplifiers with Simple Operation and High Performance
Operation so simple that essentially anyone can use the amplifier right way.
1800 E32-T11L/E32-T12L
700 E32-T11L + E39-F2
(wavelength) Red LED (620 nm) Power supply voltage 12 to 24 VDC ±10%, ripple (p-p): 10% max.
Current consumption 960 mW max. (Power supply: 24 V, Current consumption: 40 mA max.)
Control output
Open-collector output (NPN or PNP) Load power supply: 26.4 V max., Load current: 50 mA max.
(Residual voltage: 1.5 V max.) Light-ON/Dark-ON mode selector Response time Operate or reset:
200 μs max. Sensitivity adjustment UP/DOWN direct key setting
日本欧姆龙原装光纤放大器性能介绍