021-39529839
电 话：021-39526589-8004
联系人：覃小敏
手 机：19117262520
地 址： 中国 上海 嘉定区嘉涌路99弄6号713
日本原装进口油研电磁开关阀工作原理
上海乾拓贸易有限公司
联系人：杨江玲
企业QQ：2880626083
手 机：（微信）
电 话：-8012
邮箱；@163.com
地址：上海市嘉定区江桥嘉涌路6号楼713室
Models with AC Solenoids DSPG-01-C-?-20/2090
The location and the position of the cable departure can be changed. For details, see the cartridge type.
Models with DC Solenoids
two-way directional valves developed to meet the needs of this age such as energy and resources saving.
High response is provided by the poppet design. Smallest internal leakage
Internal leakage are very small, less than 5 drips per min., which is achieved by the poppet design.
fluids which may o therwise lead to breakdowns and shorten the life of the valves.
Please maintain the degree of contamination within NAS 1638-Grade 12. Use 25 μm or finer line filter. Control of Contamination
2 Viscosity ranging between 15 - 400 mm /s (77 - 1800 SSU). Oil temperatures between -15/+70°C (5 - 158°F).
Use hydraulic fluids which satisfy the recommended viscosity and oil temperatures given above.
Maximum Flow Rate The zone under each shaded line denotes the flow rate ranges being free of trouble in changeover. 2
Typical Performance Characteristics at Viscosity 30 mm /s (141 SSU) [ISO VG 46 oils, 50°C(122 °F)]
Petroleum base oils
Use phosphate ester or polyol ester fluid. When phosphate ester fluid is used, prefix
"F-" to the model number because the special seals (fluororubber) are required to be used
Shut-off Type Solenoid Operated Directional Valves DSPG-01
These ports (2) are not used. In addition, the body has the O-ring grooves and O-rings are included
in the body. The mounting dimensions conform to ISO 4401-AB-03-4-A. Ports A and B are used as ports "2"
and "1" respectively. O-rings for ports: SO-NB-P9
Fluid Types Hydraulic Fluids Any type of hydraulic fluids listed in the table below can be used.
Note: For use with hydraulic fluids other than those listed above, please consult your
Yuken representatives in advance. Recommended Viscosity and Oil Temperatures
Use water-glycol fluids or W/O emulsion type fluids.
The shut-off type solenoid operated directional valves are poppet type solenoid operated
Two mounting types: cartridge and subplate Mounting dimensions for both types conform to ISO standard.
Water-proof type (conforming to JIS D 0203 Water Spray Test 32) is also available.
Cartridge Type / Sub-plate Mounting SOLENOID OPERATED DIRECTIONAL VALVES DSPC/DSPG-01/03(1/8, 3/8)
Maximum flow rates depend on operating conditions. For details,
Due caution must be paid to maintaining control over contamination of the hydraulic
日本原装进口油研电磁开关阀工作原理
您是第33114360位访客
公司主营：德国SICK传感器，FESTO比例阀，德国FESTO电磁阀，ASCO电磁阀，NORGREN电磁阀，LEUZE传感器，CKD电磁阀，CKD气缸 沪ICP备09006758号-10
乾拓贸易是销售气缸,继电器的公司,以SMC气缸,PILZ继电器,FESTO气缸为主,产品型号规格齐全,报价合理,可满足不同客户的需求!
版权所有：上海乾拓贸易有限公司
