电 话:028-86751041-8004
联系人:王倩
手 机:15308020014
地 址: 中国 上海 嘉定区嘉涌路99弄6号713

更新时间:2024-12-20 浏览数:48
所属行业:仪器仪表> 压力仪表> 压力开关
发货地址:日本
产品规格:--
产品数量:1
包装说明:--
单 价:面议
SMC压力开关型号 ZSM1-115
1.请勿在导线过度的拉力。
这可能会导致故障或损坏。
ZSM1-1212.接线
开关可以串联连接,电压降将

增加LED的内部电阻(每个2 V的压降)。
闵在指定范围内使用开关。操作
电压。
3.膜片开关有没有内置触点保护电路。
使用带开关的触点保护盒(部件号CD-P11)与
感性负载或5μm以上引线的长度。
接触保护盒4.内部电路
SMC压力开关型号 ZSM1-115
1. Do not apply excessive pulling force on the lead wire.
It may cause a malfunction or damage.
2. Wiring of ZSM1-121
Switches may be connected in series, voltage drop will be
increased by the LED’s internal resistance (2 V drop per each).
Use switches within the specified range of min. operating
voltage.
3. Diaphragm switches have no built-in contact protection circuits.
Use switches with contact protection box (part no. CD-P11) with
inductive loads or 5 m or more lead wire length.
4. Internal circuit of contact protection box、
5.如何连接触点保护盒
从主体和接触保护连接导线
箱面标明“开关”。
引线应尽可能的短,在1微米
5. How to connect the contact protection box
Connect the lead wires from the body and the contact protective
box side indicated “SWITCH”.
Lead wire should be as short as possible, within 1 m.
SMC压力开关型号 ZSM1-115